en:retainer_3d
This is an old revision of the document!
Table of Contents
Module Retainer 3D
<WRAP group> <WRAP threequarters column>
Module Retainer 3D module can be used to construct virtual retainers based on an unsegmented or setup model created with the V.T.O.3D module.
First Steps
- Place three points defining the front point and left/right end of the retainer
- Set parameters such as height, width and precision
- Compute the retainer for each jaw
- Export the retainer as 2D path, 3D object or send it to a service provider
- Save project
Module user interface
Links
en/retainer_3d.1644236383.txt.gz · Last modified: 2022/02/07 13:19 by onyxadmin