Differences

This shows you the differences between two versions of the page.

--- en:ojob [2022/08/24 13:28] – [Overjet] onyxadmin
+++ en:ojob [2022/12/08 17:29] (current) – onyxadmin
@@ Line 1: / Line 1: @@
-====== Measurement of Overjet and Overbite on 3D findings ======
+====== Measurement of Overjet and Overbite on 3D Findings ======
 ----
-Measurement of horizontal (overjet) and vertical step (overbite) on the virtual segmented 3D model according to the definitions given below can be performed in the [[:digitize_3d|Evaluation 3D]] module using the WALA analysis for [[:tracingtypes_3d|Tracing type]] Cast Permanent 3D.\\
+Measurement of horizontal (overjet) and vertical step (overbite) on the virtual segmented 3D model according to the definitions given below can be performed in the [[:digitize_3d|Evaluation 3D]] module using the WALA analysis for [[:tracingtypes_3d|Tracing types]] Cast Mixed 3D and Cast Permanent 3D.\\
 =====Overjet=====
@@ Line 17: / Line 17: @@
   * Digitize landmark [Overjet Ant.] on the model by right-clicking¹
-{{playground:overjet1.png?600&direct}}
+{{:overjet1.png?600&direct}}
-landmark [Overjet Post.] is automatically found by projecting it vertically onto the dental arch curve of the mandible.
+Landmark [Overjet Post.] is automatically found by projecting it vertically onto the dental arch curve of the mandible.\\
 The overjet is then measured by projection into the occlusal plane and displayed in the results table.\\
-{{playground:overjet2.png?600&direct}}
+{{:overjet2.png?600&direct}}
 If landmark [Overjet Post.] is not found, it must be located manually by right-clicking it.\\
@@ Line 43: / Line 43: @@
   * Digitize landmark [RMP1] on the model with right click
-{{playground:overbite1.png?600&direct}}
+{{:overbite1.png?600&direct}}
 The overbite is measured perpendicular to the occlusal plane by distance projection into the sagittal plane and displayed for all 4 pairs of incisors.
-{{playground:overbite2.png?600&direct}}
+{{:overbite2.png?600&direct}}