[OnyxCeph³™ Wiki]

DokuWiki - World Wide Web

User Tools

Site Tools


en:waefer_creation_3d

This is an old revision of the document!


Module Waefer Creation 3D


Module Waefer Creation can be used to design surgical splints to be used during orthognathic surgery. The jaw relation can be adjusted manually using 3D virtual models or taken over from separate Waefer findings exported from module Sim 3D as a result of the treatment planning process.
To fix the splint during surgery, drill holes perpendicularly to the occlusal plane. Also labeling the waefer on its surface is possible to ensure the correct patient and splint sequense.

First Steps

  1. Define three points for the waefer plane on each the upper and lower jaw
  2. Define 2D outline for upper and lower surface with left click in sketch on the right
  3. Move 3D reference points to change the shape of the splint
  4. Optionally place additional points for texts and holes
  5. For smooth fitting on patient use options "block out interdental" and "maximum undercut"
  6. Compute Waefer object, export using the object list (right click) or upper toolbar
  7. Save as project and new finding

Module user interface


References

This website uses cookies. By using the website, you agree with storing cookies on your computer. Also you acknowledge that you have read and understand our Privacy Policy. If you do not agree leave the website.More information about cookies
en/waefer_creation_3d.1566312724.txt.gz · Last modified: 2019/08/20 16:52 by onyxadmin