en:waefer_creation_3d
This is an old revision of the document!
Waefer Creation 3D
First Steps
- Define three points for the waefer plane on each the upper and lower jaw
- Define 2D outline for upper and lower surface with left click in sketch on the right
- Optionally place additional points for texts and holes
- Compute Waefer object, export using the object list (right click) or upper toolbar
- Save as project and new finding
Module user interface
References
Complete workflow: https://www.youtube.com/watch?v=7Ohm0Ksx2k4
en/waefer_creation_3d.1559901258.txt.gz · Last modified: 2019/06/07 11:54 by martin