en:combine_3d
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
en:combine_3d [2020/04/04 16:25] – [Module Combine 3D] onyxadmin | en:combine_3d [2024/03/14 14:51] (current) – [Verweise] onyxadmin | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ~~NOTOC~~ | + | ====== Module Combine |
- | ===== Module Combine 3D ===== | + | {{: |
- | {{: | + | |
---- | ---- | ||
+ | <WRAP group> | ||
+ | <WRAP threequarters column> | ||
^ Program version | ^ Program version | ||
- | | Availablility | + | | Availablility |
+ | </ | ||
+ | <WRAP quarter column> | ||
+ | <wrap lo> | ||
+ | {{: | ||
+ | {{: | ||
+ | </ | ||
+ | </ | ||
+ | </ | ||
\\ | \\ | ||
- | Module | + | The Combine 3D module provides 2 separate modes for the combination of two 3D findings based on overlapping features to allow additional options for visualization, |
---- | ---- | ||
- | ==== First Steps ==== | + | ===== First Steps ===== |
- Open module with 2 findings | - Open module with 2 findings | ||
- Select corresponding reference points | - Select corresponding reference points | ||
Line 16: | Line 25: | ||
---- | ---- | ||
- | ==== Module user interface ==== | + | ===== Module user interface |
[[ui_module_combine_3d|{{: | [[ui_module_combine_3d|{{: | ||
\\ | \\ | ||
---- | ---- | ||
- | ==== Verweise ==== | + | ===== Verweise |
- | |{{: | + | |< 50% 10% >| |
- | | + | | |
+ | | | ||
+ | | |
en/combine_3d.1586010307.txt.gz · Last modified: 2020/04/04 16:25 by onyxadmin