Differences

This shows you the differences between two versions of the page.

--- en:bracketlib_requirements [2023/07/12 07:50] – onyxadmin
+++ en:bracketlib_requirements [2024/04/10 13:41] (current) – onyxadmin
@@ Line 1: / Line 1: @@
-======Requirements bracket file import======
+======Requirements Bracket File Import======
 ----
+{{:0544_onyx_bracket_lib.png?56|Bracket Library}}
-The CAD files should be in STL, topologically correct (especially regarding closed meshes), not larger than about 500kB per file.\\
+The CAD files should be in STL, topologically correct (especially regarding closed meshes), <wrap hi>**not larger than about 500kB**</wrap> per file.\\
-Clips of self ligating brackets should be closed.\\
+Clips of self ligating brackets should be closed. Structured bases should be avoided - use plain bases instead.\\
 We also need a table that specifies the following parameters for each file:
@@ Line 9: / Line 10: @@
   * Bracket series name
   * Single bracket order number (as per catalogue)
+  * Tooth number/s
   * Material
   * Slot size
@@ Line 17: / Line 19: @@
   * Hook: yes or no
-If thee is no written agreement already between the manufacturer (the owner of the design IP) and Image Instruments about the import of bracket CAD files to the OnyxCeph³(tm) online bracket library, a statement by the manufacturer is needed that the files are provided legally for the intended purpose.\\
+If there is no written agreement between the manufacturer (the owner of the design IP) and Image Instruments about the import of bracket CAD files to the OnyxCeph³(tm) online bracket library, a statement by the manufacturer is needed that the files are provided legally for the intended purpose.\\
+----
+//Note://\\
+<wrap hi>**Scan files cannot be used**</wrap> unless the brackets have been reconstructed based on the scan.
+\\