[OnyxCeph³™ Wiki]

DokuWiki - World Wide Web

User Tools

Site Tools


Action disabled: source
en:bracketerase

Module Bracket Erase

Module BracketErase


Program version BASIC 2D PRO 3D PRO LAB OMS
Availablility n/a n/a EUR 600 EUR 600 EUR 600

n/a not included
inklusive included by default
optional optionally included


The module Bracket Erase can be used to remove brackets and bands in a model scan. By removing these parts from the scan, you can create finishing aligners, splints or retainers, before the brackets are actually removed from the patient.
Ideally, a segmented scan of the patient from before the bracket treatment is used to replace the removed bracket geometry with the exact surface of the actual teeth of the patient.


First Steps

  1. Segment both the current scan with brackets as well as the initial malocclusion scan
  2. Open Bracket Erase module with the current scan
  3. Load the malocclusion scan as a reference scan
  4. Use automatic or manual bracket selection to define the geometry that should be replaced
  5. Select the option "Replace whole tooth" to remove bands
  6. Select the option "Show Refence" to see the fitting of the reference surface

Module user interface



This website uses cookies. By using the website, you agree with storing cookies on your computer. Also you acknowledge that you have read and understand our Privacy Policy. If you do not agree leave the website.More information about cookies
en/bracketerase.txt · Last modified: 2023/03/09 14:57 by onyxadmin